ELEC426: Advanced Communication Systems - MACQUARIE University - Engineering Assignment

Internal Code: MAS3500

Engineering Assignment Help

Questions: As shown in figure 1?1, the output of a noise source and the output of a signal generator are summed together. The resulting signal plus noise is the input of a system. The system consists of the cascade combination of: Amplifier 1, a mixer (two port frequency converter), and amplifier 2. The block diagram of this system is shown in figure 1?1. The signal is a bandpass modulated signal with a 1 MHz bandwidth. The centre frequency of the signal is 900 MHz. Amplifier 1 and amplifier 2 have bandpass transfer function characteristics. Amplifier 1 has a centre frequency of 900 MHz. The mixer down?converts a 900 MHz signal to 100 MHz. Amplifier 2 has a centre frequency of 100 MHz. Both amplifier 1 and amplifier 2 have noise equivalent bandwidths of10 MHz. The amplified and frequency converted signal does not have any signal distortion at the 50 Ohm load resistor. Part A To achieve this, what is the required RMS (root mean square) signal level at the signal generator output in volts? Note, the output of the signal generator is measured across a 50 ? resistive impedance. Part B voltage at the output of amplifier 2 in volts? Q2 A communication system uses QPSK modulation. The transmission frequency is of Fe= 2.4 GHz. The transmitter power is 1 Watt. The feedline loss between the transmitter and the transmit antenna is 2 dB. The transmit antenna is omnidirectional and has a gain of 0 dBi. The transmit antenna height is 20 meters For the receiver, the low noise amplifier has a noise figure of 7 dB, the feedline loss is 1.5 dB, the antenna temperature is 290 K, and the receive antenna gain is 3 dBi. The demodulator implementation loss is 1 dB. The receive antenna height is 1.5 meters. A. Assuming free space loss in the channel, plot the data rate that the link supports for distances between 100 meters and 20 km. Use a log-log graph to plot the data rate in bits/s as a function of distance, d, in meters.