Noise Vibration & Harshness

Assignment Task

Overview 
Automotive brake systems are susceptible to frictionally induced dynamic instabilities which can result in brake squeal whereby the brake generates an audible monotone frequency of high amplitude. Dynamic instability can be related to the coefficient of friction between the brake pad and brake disc with coupling between the pad and disc resulting in both in-plane and out-of-plane vibration. Out-of-plane vibration of the brake disc is generally accepted to cause brake squeal, with one ofthe disc diametral modes of vibration being excited to generate a squeal frequency which is slightly lower than that ofthe excited mode; a typical example of which is shown in Figure 1.

Many different techniques are involved in the analysis of brake squeal including modal analysis, dynamometer and vehicle testing and numerical modelling. During this assignment you will explore the use of modal analysis and dynamic modelling in the prediction of brake squeal.

Task 1: Experimental Modal Analysis

Shared with you excel sheets for this You will be provided with an automotive brake disc for which you are required to undertake experimental modal analysis to identify its natural frequencies and modal damping for the modes in the range of 0—20 kHz. You will work in groups to undertake the measurements, appendix. but the results and analysis must be completed individually. 

Task 2: Finite Element Modellin

You will be provided with a CAE model of the brake disc which has the material properties shown in Table 1. Using finite element analysis (FEA) predict the free-free natural frequencies in the range of 1-20,000 Hz and compare to the measured values that have been provided to you. Investigate and explain any differences in the correlation between the predicted and measured values.
1. Using finite element analysis (FEA), predict the free-free natural frequencies in the range of 1-20,000 Hz.
2. Prove that the results are mesh independent.
3. Comment on the correlation between FEA and experimental results.
4. Revise and improve your model based upon the findings from your experimental study in Task 1.

Task 3: Simulink Modelling

Develop a 4-degree offreedom Simulink model of the system shown in Figure 2 to predict both pad and disc vibration. The model represents a single pad acting on a brake disc with frictional sliding between the two bodies. A normal load, N, is generated by the piston force acting on the brake pad. The pad and disc stiffness and damping coefficients are obtained from modal analysis details can be found in the Appendix for reference only.

Analyse the resultant vibration and comment on the results. Data for the disc shown in Table 2 based upon your particular configuration will be available on Canvas, whilst the material properties of the pad can be found in Table 3. 

This Engineering has been solved by our Phd Experts at My Uni Paper. Our Assignment Writing Experts are efficient in providing a fresh solution to this question. We are serving more than 10000+ Students in Australia, UK & US by helping them to score HD in their academics. Our Experts are well-trained to follow all marking rubrics & referencing styles.

Be it a used or new solution, the quality of the work submitted by our assignment experts remains unhampered. You may continue to expect the same or even better quality with the used and new assignment solution files respectively. There’s one thing to be noticed you could choose one between the two and acquire an HD either way. You could choose a new assignment solution file to get yourself an exclusive, plagiarism (with free Turnitin file), expert quality assignment or order an old solution file that was considered worthy of the highest distinction.