UEENEEH148A - Design and Develop Advanced Digital Systems - Engineering Assignment Help

Assignment Task

Task 1

Experiment: Design the electric lock on breadboard using the following equipment:

· 4001 quad NOR gate (Radio Shack catalog # 276-2401)

· 4070 quad XOR gate (Radio Shack catalog # 900-6906)

· Two, eight-position DIP switches (Radio Shack catalog # 275-1301)

· Two light-emitting diodes (Radio Shack catalog # 276-026 or equivalent)

· Four 1N914 "switching" diodes (Radio Shack catalog # 276-1122)

· Ten 10 kΩ resistors

· Two 470 Ω resistors

· Pushbutton switch, normally open (Radio Shack catalog # 275-1556)

· Two 6 volt batteries

Task 2

There are four different parts for this task that every student must have to accomplish to gain competency in this unit:

Student has to prepare the requirement regarding designing, troubleshooting and justifying the truth table and circuit output on one the following circuit assigned by the trainer.

Part A of Given Task

Prepare to diagnose and rectify faults

OHS (Included)

In the Digital Electronics laboratory using digital gates:

a) Complete the OHS risk document attached and submit it along with the practical report.

b) Using methodical approach, show how you would test and use a Digital Trainer Board for correct functionality.

c) For the purpose of assessing your knowledge of fundamental

characteristics digital electronics circuits is applied to solving system problems, answer the following questions by showing all required steps:

i. For the digital control system as shown in the circuit diagram using digital gates list the digital IC’s required.

ii. Write the Boolean expression for the output of the digital circuit.

iii. Produce a truth table for the circuit as per the theory.

Part B of Given Task

Diagnose and rectify faults:

Practical Task

a) Carry out the OHS procedure required for this task as mentioned above.

b) Build the circuit for the above digital control system on the “Digital Trainer” provided to you in the lab class.

c) Check your circuit for proper operation.

d) Diagnose any faults in the digital control system. If no faults are diagnosed, the instructor will create “unexpected faults” which you are supposed to diagnose.

This UEENEEH148A - Engineering Assignment has been solved by our Engineering experts at My Uni Paper. Our Assignment Writing Experts are efficient to provide a fresh solution to this question. We are serving more than 10000+ Students in Australia, UK & US by helping them to score HD in their academics. Our Experts are well trained to follow all marking rubrics & referencing style.
Be it a used or new solution, the quality of the work submitted by our assignment experts remains unhampered. You may continue to expect the same or even better quality with the used and new assignment solution files respectively. There’s one thing to be noticed that you could choose one between the two and acquire an HD either way. You could choose a new assignment solution file to get yourself an exclusive, plagiarism (with free Turnitin file), expert quality assignment or order an old solution file that was considered worthy of the highest distinction.