UFM-FU7-15-3 - Computational Methods - IT/Computer Science Assignment Help

Assignment Task

Introduction 
In this assignment you are asked to provide a short report (maximum 8 A4 pages) on  the behavior of a flat plate, task 1, signboard and the signpost, task 2, using different  element types and compare the results. You will model and analyses the structure in  the ANSYS environment. 
Do not forget to apply good writing practices: structure your report, do not neglect  introduction, conclusions and bibliography, be careful with the rules around  illustrations. 
You are expected to analyses the structure using analytical and FEA method that you  consider to be appropriate for obtaining a particular level of accuracy. 
Task 1 
Perform a static stress analysis with linear material models on the problem shown in  Figure 1 utilizing different mesh densities. Use meshes of 200, 400, 800, and 1600  elements. The thickness of the part given below is 8mm. A load of n MPa is applied  on the right edge, where n is the last three digits of your UWE ID number. (for  instance, for student 14020174, n is 174). The left end is fully fixed. Material is  stainless steel (AISI 302) cold rolled. Assume it as a plane stress problem. 
Calculate stress concentration factor and compare with that of given in mechanics  textbook. Write your comments in comparison with analytical solution.

Task 2 
The signboard and the signpost, shown in Figure 2, are made of hot rolled carbon  steel (AISI 1045) and are subjected to a wind gust of 110 km/hr. The coefficient of  drag is 1.18. You will model and analyse the structure in the ANSYS environment. 

Task 3 
Use ANSYS software to conduct tutorials 1, 2, 3, 4, and 5. Use the instructions below  and steps provided in the google drive. 
Instructions: 
1. Save the file (UWE ID no_Tutorial_X), where X represent the tutorial number,  and upload them before the deadline provided in Blackboard.  
2. Do not share your solutions with other students. It is possible to trace your  simulation history and if found guilty, you may be penalized according to the rules  and regulations of UWE.

This UFM-FU7-15-3 - IT/Computer Science Assignment has been solved by our IT/Computer Science Experts at My Uni Paper. Our Assignment Writing Experts are efficient to provide a fresh solution to this question. We are serving more than 10000+ Students in Australia, UK & US by helping them to score HD in their academics. Our Experts are well trained to follow all marking rubrics & referencing style.

Be it a used or new solution, the quality of the work submitted by our assignment experts remains unhampered. You may continue to expect the same or even better quality with the used and new assignment solution files respectively. There’s one thing to be noticed that you could choose one between the two and acquire an HD either way. You could choose a new assignment solution file to get yourself an exclusive, plagiarism (with free Turnitin file), expert quality assignment or order an old solution file that was considered worthy of the highest distinction.